Studio 49 Retreat 2017 Challenge part 5 Finale

The final end to this Polwarth fiber challenge. Lots of pictures below...

Two scarf ends that needed sewing together to make a loop.

I wanted to have a flat seamless invisible join instead of an overlapped hem. I chose to cross opposite ends and loop back to the same side.

Detail of crossed warp end with needle weaving end into fabric.

 Almost done.

Ends all crossed and ready to pull each loop closed flush against the fabric.

The join turned out a little more wonky than I thought it would. It's not as invisible as intended. Instead of pulling two ends in opposite directions at the same time, I should have pulled one side flush then the other side separately. Ah well, lesson learned.

I wasn't confident the crossed ends would be secure, so very lightly, I needle felted the seam.

Then I got to the fun part...beading the fringe.

I chose three tubes of the larger glass beads, put 3 little beads on each strand and started twisting. A bigger glass bead finished off the ends.

After hand washing and air dry, WALLAH! A finished challenge project.

I had lots of little cut ends left over from the warp. I couldn't bear to throw them away. The solution: a pom pom for a keepsake. Which I finished with beads as well.

Finally, I leave today to show off these items at the Studio 49 Retreat.

Studio 49 Retreat 2017 Challenge part 4

I finally wound my hand spun Polwarth yarn onto my 10" Cricket loom and started weaving. Post for part 3 here.

Scarf in progress on the loom. The thick grey line is the BFL hand spun yarn for the weft fringe.

A close up before I took it off the loom. Nice pleasing Fibonacci color sequence eh?!?

Off the loom ready for finishing and beading. I used every bit of the white Polwarth hand spun I had (part 2 post here).

My selection of glass beads to play with.

It only took me a week to weave the scarf. Duh! Now I just need to make time to do all the finishing. Sew in the yarn tails, connect the ends in to a loop, twist and add beads to the weft fringe, and finally wet finish. Doesn't seem like much but I know it'll take me longer than I think.

Lastly, here is a picture from my sister of the yarn I spun for her (see this part 1 post) and the beads she plans to knit into her piece. I can hardly wait to see her finished cowl.

The retreat is next weekend. Gotta finish!

Studio 49 Retreat 2017 Challenge part 3

I changed my mind.

It happens often when thinking about a project. I start with one idea and it morphs into something else until finally I start. Then it morphs again. This is what's going on now with my Retreat challenge project.

The hand spun yarn was going to be a hat. I made a gauge swatch to determine what size knitting needle I wanted to use. I started with size 7 at the bottom of the swatch. That's what the pattern calls for. The middle section is size 6 needle and then the top is size 5. I placed the swatch on a stitch holder because I didn't want to cut the yarn. I intend to use every bit.

The change of plan arose when I realized that I was not enjoying knitting this yarn. I like knitting with my hand spun yarn but this one didn't feel nice or fun. I don't know why. The yarn is soft and stretchy. Lovely to hold and touch, but not to knit with apparently.

My eyes lit upon my 10" Cricket rigid heddle loom and BOOM! I had a new idea.

I am going to weave a scarf. Having limited yardage presented some challenges; 232 yards of white, 155 yards of grey. Not a lot of yarn for weaving. So I set about trying to figure out what to make with what I had. I started with the 10 dent heddle and a Fibonacci sequence in the warp. I calculated a basic scarf at 8"x72" and discovered I did not have enough yarn. I want to feature the white Polwarth with a few grey BFL stripes.

I was inspired by the Biscuits and Jam Scarf by Sarah Jackson featured in the May/June issue of Handwoven Magazine. I'm lucky enough to be a fellow guild member of Sarah's and saw the beautiful scarf in person at the SCWSG June meeting. She wove hers in cotton with beaded weft fringes. Then sewed the ends together to make a circular scarf. I really liked the weft fringe idea.

I made drafts on paper first. Then I made a yarn wrap to see if I liked how the Fibonacci sequence looked.

I drew a scarf close to 1/8" scale and made more calculations. One set with 80 ends for an 8" wide scarf and one with 70 ends. I have just enough yarn (I think/hope) to make a scarf 7" wide with a weaving length of 60". There will be a small plaid section where I put another Fibonacci sequence in the weft at one end of the scarf.

If I run out of white weft then it will be a little shorter. But that's OK since I want to sew the ends together to make a loop and wear it like a cowl anyway.

I think I'm ready to start...

Studio 49 Retreat 2017 Challenge part 2

See this post for the beginning of this story.

I have finished spinning my yarn for the Studio 49 Retreat 2017 challenge. Yay! I scaled down my vasty many oz. project idea from last year. I decided that finishing it without undue stress and last minute spinning/knitting was going to be better for my health and for my family.

So the new project idea is to spin just the original 2oz. of creamy white Polwarth and 2oz. of lovely natural grey BFL (BlueFaced Leicester) I have in my stash. I will finish two separate yarns and knit a 2-color Mosaic Sampler Hat. A new technique and a small doable project! Sort of unusual for me. But smart this time around.

My singles.

I wanted a 2 ply yarn so I needed to divide the singles into two sections to ply. I didn't want to ply from a single ball for some mysterious reason. Here is my set up. I weighed an empty bobbin then weighed the full bobbin and did some calculations to figure out what my end half bobbin should weigh so I had two close to even singles ready to ply.

The red box is my homemade shoe-box lazy kate with tension device. I made her when I first started spinning in 2003 and she is still my go-to kate. Almost there with the divided singles.

Two pairs of singles!

Plying set up.

I used my 1970's Ashford Traditional spinning wheel with the jumbo bobbin set up to ply both yarns into big skeins. I added a couple extra treadle pushes to get the tighter twist I wanted.

My two finished skeins and a close up of the lovely yarn. The grey BFL is a wee bit thicker than the Polwarth.

The yarns wet finished nicely. Both are soft and squishy. The Polwarth in particular is stretchy and the creamy white just glows. It's going to be fun to knit the hat. But first...must knit a swatch!